Brother DCP9040CN Quick Start Manual page 6

DCP9040CN, DCP9045CDN, MFC9440CN & MFC9840CDW
PAPER FEED FRAME – INSTALLATION
1. Place the belt cleaner release harnesses back on the printer frame. Be sure to place the wire harness on
the paper feed frame assembly back through the harness guide.
2. Place the wire harnesses back into the PF CR harness. The wide end of the PF CR harness will face the
bottom of the machine when installed. Feed the wire harness back through the printer frame BEFORE
attaching it to the printer frame. Leave slack in the wire harness.
3. Place the frame unit back in the machine with the assembly as far to the RIGHT as possible. DO NOT
push it to the left at this time. Be sure that the metal ground tab for the center screw is not caught under
the frame unit.
4. Locate the white cam shown in figure 1. Use a screwdriver or other object to hold the cam in the UP
position (pushed towards the back of the machine). Leave the cam in this position during the installation
procedure.
NO PAPER FEED Message, Clicking Noise
March 3, 2008
Figure 1
Page 6 of 10
SERVICE
UPDATE No.
F1249