Table of Contents
Advertisement
EN
NL
4.9.1 Limited driving speed
For your safety, the driving speed of your wheelchair will be automatically reduced when certain
body position alterations have been made. The drive of the wheelchair is then limited to the lowest
speed setting D1, or even becomes completely blocked.
Driving and speed limitations occur when:
• the lift has been adjusted to a higher position. Only
speed setting D1 is available.
• the backrest inclination exceeds a certain angle
(see figure 15):
1. All functions of your wheelchair are available.
2. Only speed setting D1 is available.
3. Driving your wheelchair is no longer possible.
Raise the backrest until the block is lifted.
To lift the speed/driving limitations, lower the lift to standard (lowest) position, and adjust your
seat and backrest to upright sitting position.
4.10
Adjusting the chin controller
The chin controller can be adjusted in several directions to make the driving experience as
comfortable as possible for the user.
4.10.1 Adjusting the vertical position
The height of the chin controller can be altered in two
ways.
• At the back of the wheelchair: Loosen the star knob
to move the controller support up/down until the
desired height.
• On the controller support: Loosen the screws (5) to
adjust the position of the controller support arm.
4.10.2 Adjusting the horizontal position
The horizontal position of the chin controller can be altered in two ways.
The chin controller itself:
1. Loosen both screws (6) on the bottom of the
chin controller.
2. Move the chin controller sideways on the
support arm until the desired position is
reached.
3. Turn the chin controller forwards/backwards
until the desired position is reached.
2
3
14
SE04, SE104
2021-11
Operating console functions
1
Backrest inclination
5
6
Advertisement
Table of Contents
