Door Lock - Bticino 374000 User And Installation Manual

Entrance Panel 10"
User and installation manual

Door lock

In this section it is possible to set different parameters of the EP door lock
1
2
A A It restores the factory settings
1. Door Status
The Door Status function allows to receive door status notifications, and therefore a warning
when the door is left open.
To use this function, a clean contact in the GND SENSE input clamp is required.
Touch to set a door status alarm:
NO = sends an alarm when the contact remains open for more than 2 minutes
NC = sends an alarm when the contact remains closed for more than 2 minutes
Not used never sends alarm
The alarm is displayed on both the SSDES and GS
2. Door Lock
The lock connected to the Lock+ / Lock- clamps can be controlled using pulse or timed
commands
Touch to set the timed mode
3. Touch to set the impulsive mode
4. Enter the contact activation time in seconds
5. Touch to save the setting
48
5
3
A
4