Roborock Q7+ User Manual page 8

❶ Downloading App
Option 1: Search for "Roborock" in the App
Store or Google Play or scan the QR code to
download and install the app.
Option 2: Search for "Mi Home" in the App
Store or Google Play or scan the QR code to
download and install the app.
❷ Reset WiFi
1. Open the upper cover and find the WiFi
indicator.
2. Press and hold the and
until you hear the "Resetting WiFi" voice
alert. The reset is complete when the WiFi
indicator flashes slowly. The robot will then
wait for a connection.
Note: If you cannot connect to the robot due to your router
configuration, a forgotten password, or any other reason,
reset the WiFi and add your robot as a new device.
❸ Add device
Open the Roborock App, tap the "Search for
device" button, or open Mi Home app, tap "+"
in the top right corner and add the device as
instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 1 hour for a connection, WiFi
will be automatically disabled. If you want to reconnect,
reset the WiFi before proceeding.
Instructions for Use
On/Off
Press and hold the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
and hold the
and complete the cleaning cycle.
Note: The robot cannot be turned off when it is being charged.
Starting Cleaning
Press the
buttons
robot will plan its cleaning route according
to its scan of the room. It splits a room
into zones, first draws out zone edges, and
then fills the zone in a zigzag pattern. In
so doing, the robot cleans all zones one by
one, efficiently cleaning the house.
button to turn on the
button to turn off the robot
button to start cleaning. The
08
Zone 1 – Cleaned Zone 2 – Cleaned
Zone 4 – Next Zone Zone 3 – In Progress
Notes:
• Cleanup cannot start if the battery level is too low. Allow the
robot to charge before starting cleanup.
• If cleanup is completed in less than 10 minutes, the area will
be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
Pause
Press any button to stop the robot during
operation. Press the button to resume
cleanup. Press the button to send the robot
back to the dock and end the current cleanup.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button to
wake it up.