Operation - Parkside PFBS 12 C5 Operation And Safety Notes

Start charging
Connect the USB-C plug on the USB
charging cable
[ 5 ]
.
[ 4 ]
Connect the USB-A plug on the USB
charging cable
[ 5 ]
Connect the charger to a mains power
socket .
The battery is fully charged when the battery
LED lights up red/orange/green .
[ 2 ]
Stop charging
Disconnect the USB charging cable
the product .
Pull the charger out of the power outlet .
Checking the battery charge level
If the product is switched on, the remaining
charge is indicated by the battery LED
Battery LED
2 ] [
Red/orange/green Maximum charge
Red/orange
Red
˜ Changing/inserting the tool/
collet chuck
m WARNING!
Always switch the product off and let the
u
product cool down before cleaning or
making any adjustments!
to the charging socket
to the charger .
from
5 ] [
:
2 ] [
Charging level
Medium charge
Low charge: Charge the
battery
m CAUTION! RISK OF INJURY!
Keep your hands away from the
u
accessory tool when the product is in

operation .

After the product has been switched off,
u
the accessory tool continues moving for
some time . Do not touch the accessory
tool and do not attempt to brake it .
Only use accessory tools recommended
u
by the manufacturer . Using other
accessory tools and other accessories can
represent a risk of injury for you .
Only use accessory tools, which bear
u
information about the manufacturer, type
of binding, dimension and permitted
number of revolutions .
Only use accessory tools where the
u
printed rotational speed is at least as high
as what has been specified on the product
marking .
Do not use any broken, cracked, or
u
otherwise damaged accessories .
Only use flawless accessory tools .
u
Ensure that the accessory tool dimensions
u
match those of the product .
Never re-drill a locating hole which is too
u
small to make it larger .
Never use separate bushings or adaptors
u
in order to make wheels with a hole that is
too large fit the product .
Support plates or workpieces to reduce
u
the risk of kickback from a jammed wheel .
Large workpieces may bend under their
own weight . The workpiece must be
supported on both sides of the wheel,
near the wheel as well as at the edge .
GB 19