Sagi KP12G1M Use And Installation Manual page 91

The buzzer sounds.
The buzzer can be turned off by pressing the key
The visual warning signal stays on until the card is set to stand-by.
! If the problem causing the alarm reoccurs on restarting the system, the signal [HP]
will be displayed again.
In this case, all the relay outputs are de-activated except the condenser fan output.
Defrost may be either manual type or automatic type.
Manual defrost
The defrosting process can be stopped manually by pressing the
seconds. When the process is stopped, a signal blinks on the label display [ndF].
Automatic defrost
Automatic defrost is started during the conservation phase and is regulated by the card
set-up.
The defrosting process can be stopped manually by pressing the "up" key again for 4
seconds. When the process is stopped, a signal blinks on the label display [ndF].
Press this key for 3 seconds and release it as the display shows the [Sby] to set the
appliance to the stand-by mode.
WARNING: the main switch
current.
Set the general cut-out in OFF position.
To isolate the unit from electrical tension disconnect its plug from the outlet.
DEFROSTING
Push the button defrost for 4 sec seconds to immediately
activate the defrost cycle.
Just before the defrosting process begins, the temperature of
the blocked cell is displayed.
STOPPING
DOES NOT insulate the machine from the electric
21
.
key again for 4