Sagi KP12G1M Use And Installation Manual page 82

The air condenser should be kept clean to ensure the device performance and efficiency,
as air should circulate inside the device without barrier.
WARNING: The condenser should therefore be cleaned every 30 days or as needed
A dirty Condenser can result in NON-WARRANTEED part & Compressor Failures, Product
Loss.
Before to begin with the operations proceed as following:
- set the general cut-out in OFF position;
- remove the plug from the socket and wait till the complete entfrosting of the unit.
To access the condenser it is necessary to remove the front dashboard:
1. Remove the lower instrument panel, grasping it on the side, freeing it from the four
retaining bolts.
2. Remove the cable from the panel control board.
3. use a vacuum cleaner, brush or non-metallic brush to carefully clean the condenser.
Accurately clean the condenser in the refrigerating unit and the inner evaporator with
either a vacuum cleaner, a bristle brush or a non-wire brush after removing the
protections.
Perform lubrication to ensure regular operation of the "soft motion" flapdoor opening
system.
ATTENTION: the operations described must be carried out by specialised technical
personnel.
- Remove the two front guards, unscrewing the fixing screws on the internal sides of the
same; to complete this operation the doors must be opened one at a time.
- Remove any traces of dust and/or dirt.
12