Sagi KP12G1M Use And Installation Manual page 80

The display case is predisposed to be panelled on three sides, or else inserted into a suitable
recessed location.
The appliance is equipped with doors that open downward, equipped with gas springs
which ensure closing in a controlled manner. In any case, always accompany the door with
your hand when closing.
To lock the door in the open position, guide it to its fullest open position.
To close a door in the locked position, grasp the handle with your hand and accompany
the door until it is closed.
Open the lower door and bring it to its locked
position.
Delicately remove the shelves, taking care not to
damage them. Position the shelves in a safe
location.
Remove the wooden and polystyrene parts inside the appliance.
To install the shelves, follow what is indicated below:
• Pre-assemble the shelf supports on the racks, taking care to properly position the rear
supports (larger) and the front supports (smaller) at the same height.
• Make sure that the steel support hooks are inserted properly in the rack holes. To
ensure proper support insertion, use a small hammer with a rubber head, if necessary.
• Insert the various shelves, making sure not to subject them to impact.
WARNING: Make sure that the unit is not exposed to direct sunlight, or any other sources of
heat nor placed in environments with high temperatures; any of these would cause the unit to
wear more quickly and perform poorly.
10