Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR CONTEMPORARY FACADE KITS
FOR USE WITH GEMINI CD AND DRC3000 FIREPLACES
Panel
f i r e - p a r t s . c o m
Trim
Contemporary Facade Units
35" Models
Description
Cat. No.
Choose One Base Kit
Facade Base Black
F2460
Facade Base
F2461
Stainless
And Choose One Panel Kit
Facade Panel Black *
F2464
Facade Panel
F2465
Stainless *
Table 1
* The panel kits include trim.
GENERAL INFORMATION
The Contemporary Facade Kit is composed of two separate elements
(one base kit and one panel kit with trim) that are purchased separately.
Refer to Table 1.
NOTE: To complete one Facade a selection of one Base and one Panel
kit must be made.
The Panel must be installed on a properly positioned Gemini CD or
DRC3000 fi replace. Refer to Installation and Operation manual for detailed
instructions. Refer to Table 2 for facade signifi cant dimensions.
Frame
Base
40" Models
Model No.
Cat. No.
Model No.
FBBK35CD
F2462
FBBK40CD
FBSS35CD
F2463
FBSS40CD
FPBK35CD
F2466
FPBK40CD
FPSS35CD
F2467
FPSS40CD
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
P/N 506020-32
Rev. A, 08/2016
E
Facade Dimensions
A
44-1/2
35" Model
(1130)
49-1/2
40" Models
(1257)
Table 2
INSTRUCTIONS
Figure 1
Start by locating the fi replace face brackets indicated by the arrows
at the top Figure 1 and the fi replace face foot slots indicated by the
arrows at the bottom of Figure 1. Proceed with the steps on Page 2.
HEARTH PRODUCTS
KITS AND ACCESSORIES
CONTEMPORARY FACADE KITS
A
C
F
B
C
D
E
32-7/8
35-1/2
23-7/8
29
(835)
(902)
(606)
(737)
37-7/8
40-1/2
28-7/8
34
(962)
(1029)
(733)
(864)
B
D
F
16
(406)
21
(533)
1
Advertisement
Related Manuals for IHP F2460
Summary of Contents for IHP F2460
- Page 1 Cat. No. Model No. 40” Models (1257) (962) (1029) (733) (864) (533) Choose One Base Kit Table 2 Facade Base Black F2460 FBBK35CD F2462 FBBK40CD Facade Base INSTRUCTIONS F2461 FBSS35CD F2463 FBSS40CD Stainless And Choose One Panel Kit Facade Panel Black *...
- Page 2 Step 1. Slide top trim pieces over fl ange of panel until seated squarely. Step 2. Slide side trim pieces into place (top will overlap slightly). Repeat Step 1 and Step 2 for bottom and opposite side trim for panel. f i r e - p a r t s .
- Page 3 Fireplace Face Bracket Facade Base Cutouts Step 4a. Slide the foot tabs of the facade base into the slots (see Figure Step 4b. Tilting the facade base up on its foot tabs, secure the top by 1) on both sides near the bottom of the fi replace opening. engaging the three brackets (see Figure 1) on the face of the fi...
- Page 4 - p a r t s . c o m IHP reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distributor for fi...