All manuals and user guides at all-guides.com
resistance measurements. Press
between the bias voltage (BiAS) display or
leakage current (LEAk) display, calculated
based on the bias voltage and corrected
resistance value, on the secondary display.
Continuity tests
Set up your multimeter as shown in the figure
below to perform continuity tests. Press
switch to the continuity test function (
shown on the display).
The beeper will sound as a continuity indication.
Press
and normal close (
– Normal open: Circuit is normally open, the
beeper will sound when a short is detected.
– Normal close: Circuit is normally closed, the
beeper will sound when an open is detected.
16
to switch between normal open (
Dual
E xit
) contacts.
Keysight U1273A/U1273AX Quick Start Guide
to switch
Dual
E xit
to
is
)