Advertisement
Available languages
Available languages
3.2 PROGRAMMING THE LEARNING REMOTE
The remote control for the receiver has 4 buttons with the "learning" function.
Each of the four buttons can be programmed to function for certain buttons on
the TV remote control.
1. The remote control has 4 programmable buttons to control the TV:
TV Power, Vol +, Vol-, TV /AV
2. Place the receiver remote control and the original TV remote control
facing each other within 3-5 cm.
3. Press the SET button on the receiver's remote control for 3 seconds,
the red LED will flash from low light to brighter light-then release the SET
button.
4. Press and release the button you want to program,eg TV Power (the red
LED will start blinking).
5. Press the Power button on the remote control of the TV,the LED should
blink 2 times and stay on steadily,release the button.
6. After programming is complete,press the SET button,the LED will turn off.
Programming complete.
7. Repeat the same steps to program the other buttons.
BATTERY !INSTALLATION:
1.0pen the battery compartment.
2.1 nsert 2 AAA batteries with the oorrect
polarity(+/-).
3. Close the battery compartment.
Caution:
Do not use two different batteries.
Remove the batteries if there the remote control is not used for a long time.
Do not expose the remote control to direct sunlight or excessive heat sources.
Advertisement
