Polaroid P75 Series User Manual page 3

W W A A R R R R A A N N T T Y Y I I N N F F O O R R M M A A T T I I O O N N
WE NEED TO HEAR FROM YOU!
To establish Your Warranty Period And Provide Access To Technical Support, Send Us your
Warranty Registration Card Today!
Polaroid warrants the mechanism, control electronics and power supply, under normal use and serv-
ice, to be free from defects in material and workmanship for a period of twelve (12) months from
the date of purchase by the end user. Polaroid warrants the print head, under normal use and serv-
ice, to be free from defects in material and workmanship for a period of twelve (12) months from
the date of purchase by the end user. Proof of purchase is required. If proof of purchase cannot be
established, shipment date to the original buyer (dealer or distributor) will be used to establish the
warranty period.
Failure to exercise caution to protect the equipment from electrostatic discharge damage, adverse
temperature and humidity conditions or physical abuse, including, but not limited to, improper pack-
aging, shipping, service or repairs performed by personnel not authorized by Polaroid may void the
warranty. Failure to use only Polaroid approved media may void the warranty.
Polaroid will, at its option, repair or replace the equipment or any parts which are determined to be
defective within this warranty period, and which are returned to Polaroid.
The warranty set forth above is exclusive and no other warranty, whether written or oral, is
expressed or implied. Polaroid specifically disclaims the implied warranties of merchantability and
fitness for a particular purpose.
D D E E C C L L A A R R A A T T I I O O N N S S O O F F C C O O N N F F O O R R M M I I T T Y Y
73/23/EEC modified
Model: P75 conforms to the following specification:
FCC Part 15, Subpart A, Section 15.107(a) and Section 15.109(a) Class
A digital device
Supplemental Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following Two
Conditions: (1) This device may not cause harmful interference , and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmfull interference when the equipment is operated in a commercial envi-
ronment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmfull interference
to radio communications. Operation of this equipment in a residential area is likely to cause
harmfull interference in which case the user will be required to correct the interference at his
own expense.
I I N N D D U U S S T T R R Y Y C C A A N N A A D D A A N N O O T T I I C C E E
This device complies with Industry Canada ICS-003 class A requirements.
Cet équipement est conforme à l'ICS-003 classe A de la Norme Industrielle Canadienne.
iv
E E u u r r o o p p e e a a n n C C o o u u n n c c i i l l D D i i r r e e c c t t i i v v e e
89/336/EEC
EMC Directive
modified by
92/31/EEC and
EMC Directive
93/63/EEC
Low voltage
by 93/68/EEC
C C o o m m p p l l i i a a n n c c e e t t o o S S t t a a n n d d a a r r d d s s
EN 55022-B
EN 500082-1,
1992
EN 60950
Directive
RF Emissions
control
Immunity to
Electromagnetic
Disturbances
Product Safety