Polaroid P75 Series User Manual page 16

C C a a r r d d t t h h i i c c k k n n e e s s s s : :
A - 60mil (1.524mm) to 50mil (1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
D - 20mil (0.508mm)
E* - Less than 20mil (0.508mm)
* Start at lowest position and move lever up to
match card thickness.
For other card thickness, start lever at lowest
position and move up until cards feed.
2.6
C C - - C C A A R R D D T T H H I I C C K K N N E E S S S S C C O O N N T T R R O O L L L L E E V V E E R R
This item is operated by the user to prevent
more than one card feeding into the printer
at the same time and causing a jam.
Open Cover, and adjust lever to correct
position. Repeat for different card thickness.
(Factory setting is for 30mil (0.762 mm) card
thickness. See diagram below :
D D - - C C A A R R D D O O U U T T P P U U T T H H O O P P P P E E R R
For collecting printed cards.
Install Card Output Hopper onto printer by
hooking over bottom edge of card exit
aperture.