Control Panel - Hisense AP-10DR2SFTS10 Use And Installation Instructions

Control panel

WiFi
@)
,a.
'i'
POWER
symbols may be different from these models, but the functions are sim ilar.
NOTE:The
Power On or Off
0
©)
POWER
NOTE:
Keep upright et least 2 hours before use to prevent
damaging the compressor.
At the first time when the air conditioner is plugged in and turned
on after your purchase, it will be set in Cool Mode. When the air
conditi one r is tu rned on at all othe r times,
to t h e previous setting.
Mode
1. Press and release MODE unti l you see the symbol for the
des i red setting.
Operating modes:
MODE
Dry,
2. Choose Cool , Fan or Heat.
Cool -Cools the r oom. Press FAN to select High, M i d or Low
speeds. Press the Plus or M inus button to adjust the tem perature .
Q
COOL
Dry-Dries t he r oom. The ai r conditi one r a utomatically
selects the te m p e r ature. The fan runs on Low speed only .
De h umidificati on ranges betwee n 2 to 3 pints pe r h ou r, by
model .
Starting Your Portable Air Conditioner
0
Q COOL
12
�
Q DRY
Q
FAN
MODE
Q
HEAT
w ill r u n accord ing
it
El
HIGH Q
o,
(!)
'F Q
MED
LOW Q
FAN
NOTE: Dry mode s h ould n ot be used to cool the r oom.
Q DRY
Fan Only mode. Press FAN to select High,
Mid or Low.
Q FAN
Heat- heats the room. Press FAN to select high, M i d or Low
speeds . Press the PLUS or MIN US button to adjust the
tem perature.
NOTE: Heating is NOT available for cooling only models.
Q
WIFI
control is available for connected models with this
l ogo on control panel.
� WiFi
Fan Speed
1. Press and release FAN to ch oose t he desired fan speed.
2. Ch oose H igh, Mid or Low.
High-for m aximum fan speed
Q
HIGH
Mid-for n ormal fan speed
MED Q
Low-for minimum fan speed
LOW Q
12
QTIMER
O(E)
Q SLEEP
HEAT (Optional)
{Optional )
FAN