Using The Remote Control - Hisense APC12 Series Use And Installation Instructions

Temperature
Press the PLUS button to raise the temperature. Press the PLUS
button once to increase the set temperature by
PLUS
Press the MINUS button to lower the temperature. Press the MINUS
button once to decrease the set temperature by
MINUS
NOTE:
In the Cooling mode, the temperature can be set between
16°C and 30°C .
In Fan Only mode, the temperature cannot be set.
Insert the Batteries
1. Remove the battery cover to the arrow direction.
2. Insert new batteries making sure that the (+) and (-) of
battery are matched correctly.
3. Reattach the cover by sliding it back into position.
NOTE:
Use 2 LR03 AAA(1.5volt) batteries. Do not use rechargeable batteries.
Replace batteries with new ones of the same type when the display
becomes dim, or after 6 months.
If you reload batteries over after removing the old ones, you will miss
the presetting and the timer will go back to Zero.
Storage trip
The clip on the back of the unit can be used to store the remote
control.
ION (Optional)
Press the ION button to start or stop the Plasma Generator.
1°C.
When the ION indicator light of the appliance flashes,
Plasma Generator will turn on.
1°C.

Using the Remote Control

Signal receptor
18
Holder
How to Use
To operate the room air conditioner, aim
the remote controller to the signal receptor.
The remote control will operate the air
conditioner at a distance of up to 23' (7m) when
pointing at signal receptor of the air conditioner.
the