Polaris RANGER XP 1000 2020 Owner's Manual page 101

POLARIS VARIABLE TRANSMISSION (PVT)
SYSTEM
Failure to comply with the instructions in this warning can result in severe injury
or death. Do not modify any component of the PVT system. Doing so may
reduce its strength so that a failure may occur at a high speed. The PVT
system has been precision balanced. Any modification will cause the system to
be out of balance, creating vibration and additional loads on components.
The PVT system rotates at high speeds, creating large amounts of force on
clutch components. As the owner, you have the following responsibilities for
• Always follow all recommended maintenance procedures. Always look for
and remove debris inside and around the clutch and vent system when
replacing the belt.
• See your dealer or other qualified service person as outlined in the owner's
manual.
• This PVT system is intended for use on POLARIS products only. Do not
install it in any other product.
• Always make sure the PVT housing is securely in place during operation.
BELT REMOVAL
If a belt fails, always clean any debris from the clutch air duct and from the clutch
and engine compartments when replacing the belt.
Failure to remove ALL debris when replacing the belt could result in vehicle
Inspect the entire clutch outlet duct (including the outlet duct screen) when
replacing a drive belt. Remove any debris found in the outlet duct or outlet duct
To remove the belt, do the following:
Downloaded from ManualsNet.com
your own safety and the safety of others:
damage, loss of control and severe injury or death.
search engine
WARNING
WARNING
NOTE
screen.
MAINTENANCE
99