Reset Button - MikroTik BaseBox Series User Manual

1. Remove top cover;
2. Unscrew two screws on the back of the device;
3. Open Ethernet port cover and withdraw it from the base of the device;
4. Unscrew the antenna connector;
5. Withdraw the PCB plate from the base cover;
6. Install your modem and reassemble.

Reset button

The reset button has three functions:
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration (total 5 seconds).
Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will now look for a CAPsMAN server (total 10
seconds).
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers (total 15
seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.