Casio EXILIM EX-S7 User Manual page 171

Problem
Images cannot be
transferred over a
USB connection.
Language selection
screen appears
when the camera is
turned on.
The time and date
settings configured
the first time after
purchasing the
camera are reset to
their factory
defaults when
remove the
camera's battery.
Possible Cause and Recommended Action
1)The USB cable may not be connected securely. Check all
connections.
2)The wrong USB communication protocol is selected. Select
the correct USB communication protocol in accordance with
the type of device you are connecting (pages 124, 133).
3)If the camera is not turned on, turn it on.
4)Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer's USB port.
1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 20, 146).
2)There may be a problem with the camera's memory data. If
this is the case, perform the reset operation to initialize the
camera's setup (page 149). After that, configure each setting.
If the language selection screen does not re-appear when you
turn the camera on, it means that the camera's memory
management data has been restored.
If the same message appears after you turn power back on,
contact your retailer or a CASIO authorized service center.
Load the camera's battery and reconfigure the time and date
settings (page 20). Do not remove the battery from the camera
for at least 24 hours after configuring time and date settings.
After that, the settings will not be reset if you remove the
battery.
• If the time and date are reset to their factory default settings
when you remove the battery after it has been loaded for
more than 24 hours, it could mean that the camera's setting
memory is defective. Contact your retailer or a CASIO
authorized service center.
171
Appendix