Moving Your Appliance; Freezing And Storing Food In The Freezer - Proline PLCH103-1 Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

When you use the appliance for the first time or after defrosting,
adjust the control knob to the coldest setting for at least 2 hours
before introducing food to be stored, and then readjust to the
middle setting.
High temperature alarm
When the temperature in the freezer is higher than -5°C, the red
alarm indicator light will illuminate.
During the alarm phase, do not place food inside the freezer. When
normal conditions are restored this indicator light will go out.

MOVING YOUR APPLIANCE

If the appliance is turned off for any reason, wait for 10 minutes
before turning it back on. This will allow the refrigeration system
pressures to equalise before restarting.
• Turn off the appliance and unplug it from the mains socket.
Remove all food. Also remove all mobile parts (baskets, accessories,
etc.) or fix them into the appliance to avoid any shock.
• Relocate and install. If the appliance has been left on its side for
any length of time, leave it standing upright for at least 10 minutes
before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although
R600a is an environmentally friendly and natural gas, it is explosive.
Therefore you should be careful during shipment and installation to
prevent your appliance's cooler elements from being damaged. In
the event of a leak caused by damage to the cooler elements, move
your appliance from open flame or heat sources and ventilate the
room where the appliance is located for a few minutes.

FREEZING AND STORING FOOD IN THE FREEZER

Using the freezer
To store deep-frozen food.
To make ice cubes.
To freeze food.
Note: Ensure that the freezer door has been closed properly.
EN-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Plch203-1

Table of Contents