Others; Troubleshooting - Whirlpool CS2320 Manual

■ Troubleshooting

A. Possible Problems
Problem
1 No Display
2 Combi steamer is not working
3 Display is not working properly
Lots of Water or steam can be
4
found during cooking
5 Oven light is not working
6 Fan motor fails to work properly
Control panel is not working
7
properly
8 No steam
9 Water leakage
S48893-Whirlpool Combi Steamer User Manual_EN_V12.indd 88-89

Others

Cause Solution
Combi steamer is not connected Ensure it is connected to power
to power supply supply
Check if other electrical appliances
Malfunction of power socket
work normally
Power cords is not working Contact after-sales service
Power supply plug is not Try to plug in the power supply
connected correctly again
Oven door is not closed properly Close the oven door again
Water tank is not in a correct
Put the water tank back correctly
position
Circuit board is damaged Contact after-sales service
Child lock is enabled Disable the child lock
Display is damaged
Contact after-sales service
Circuit board is damaged
Oven door is not closed tightly Close the oven door tightly again
Door seal is damaged Contact after-sales service
Light is damaged
Contact after-sales service
Control board is damaged
Fan motor is damaged
Contact after-sales service
Control board is damaged
Control panel is out of order
Contact after-sales service
Control board is damaged
Water tube is damaged
Water pump is damaged Contact after-sales service
Water tank is empty or not in place
The water tank is not in a correct Fill the water tank and put it back
position correctly
88
Others
B. Following conditions are normal
Condition
Fame and smell can be detected during the first
1
time of use
2 Noise can be heard using any steam related mode
Water condensation can be found around the
3
ventilation vent or door
4 The fan continues to work after cooking is finished
5 White powder can be found around the air inlet
6 Bottom and cavity of oven's color has yellowing.
89
Cause
These are emitted by the protective oil and it is
normal.
This is normal during water pumping into machine
for steaming.
The combi steamer produces a large amount of
steam under steam cooking mode. Most of the
steam will be vented from the frontal ventilation and
some condensation water will be found around the
ventilation vent.
The fan will continue to run for 3 minutes after each
cooking mode for cooling purpose to discharge oven
heat completely. It is normal.
This is water scale. It is normal. If white powder
(water scale) is detected, it is recommended to run
the Descaling Mode for cleaning purpose.
Stainless steel will generate yellow marks when
heated and not kept clean. It is recommended to
clean the combi steamer after each use to avoid
the yellowing issue caused.
26/7/2016 下午12:55