Setup Via Keypad And Monitor; About The Setup Of Viewcom/E Max; About The Monitor View; To Go To The Setup Mode Of Viewcom/E Max - FLIR VIEWCOM/E MAX+ Setup Manual

2. Setup via keypad and monitor

About the setup of VIEWCOM/E MAX+

There are two possible ways to set up VIEWCOM/E MAX+:
Location
On site Keypad and monitor
Remotely PC (VIEWCOM/E MAX+ Web page)
See
To access the Web page of VIEWCOM/E MAX+, it is required that an IP address has been assigned via the on-site
setup.

About the monitor view

Via the monitor you can view the VIEWCOM/E MAX+ in:
• Operational mode, showing product information, detector board overview and list of events
See Display information of VIEWCOM/E MAX+ in operational mode
• Setup mode, with the setup menu (keypad needed)

To go to the setup mode of VIEWCOM/E MAX+

1 Press the RESET button on the front panel of the VIEWCOM/E MAX+ board.
Product information (product name, serial number, version number) is shown.
2 Press the M key on the keypad.
3 To exit the setup mode: from the main menu, press the Escape key.
Setup via keypad and monitor
> About the setup of VIEWCOM/E MAX+
Using
VIEWCOM/E MAX+ Web page
Initially set up the board
Change the setup of an operational board
on page 11.
on page 10.
2
To