To Assign An Ip Address; To Change The Time Interval For Data Retrieval; To Set The Number Of Cameras Connected To Viewcom/E Max - FLIR VIEWCOM/E MAX+ Setup Manual

Note: Serial communication between VIEWCOM/E MAX+ and an external device is possible over the service
connector on the front panel of VIEWCOM/E MAX+. The Communication menu includes the settings
Baudrate.

To assign an IP address

1 Select Communication > Ethernet.
2 Select System IP and Subnet Mask and type a new string to change these settings.
3 To connect to other networks: enter another value to set the Default Gateway.
4 To change the default port of the PC: select TCP Port. and enter a new value.
5 Press the Escape key.

To change the time interval for data retrieval

1 Select Communication > Data Integration Interval and use the Arrow keys (Interval range: off, 10, 20 or 30 s, 1,
2, 3, 5, 6, 10, 15, 30 or 60 min).
2 Press the Escape key.

To set the number of cameras connected to VIEWCOM/E MAX+

1 Select Communication > Number of Cameras and use the Arrow keys.
2 Press the Escape key.
Setup via keypad and monitor
> To assign an IP address
6