Before Performing Any Electrical Work, Read These Regulations - Beko BIHPR 090 User Manual

4 Installation
drain hose.
• Wrap the connection point firmly with Teflon
tape to ensure a good seal and to prevent
leaks.
• For the portion of the drain hose that will re-
main indoors, wrap it with foam pipe insulation
to prevent condensation.
• Remove the air filter and pour a small amount
of water into the drain pan to make sure that
water flows from the unit smoothly.
C
Make sure to arrange the drain
hose according to the following
figures.
CORRECT
CORRECT
Make sure there are no kinks
Make sure there are no kinks or
or dent in drain hose to ensure
dent in drain hose to ensure proper
proper drainage.
drainage.
NOT CORRECT
NOT CORRECT
Kinks in the drain hose
Kinks in the drain hose will create
will create water traps.
water traps.
24 / 116 EN
NOT CORRECT
NOT CORRECT
Kinks in the drain hose will create Kinks in the drain hose
will create water traps.
water traps.
NOT CORRECT
NOT CORRECT
Do not place the end of the
Do not place the end of the drain
drain hose in water or in
hose in water or in containers that
containers that collect water.
collect water. This will prevent
This will prevent proper
proper drainage.
drainage.
Plug the unused drain hole. To
prevent unwanted leaks you
must plug the unused drain
hole with the rubber plug
provided.
4.2.3 Before performing any electrical
work, read these regulations
1. All wiring must comply with local and national
electrical codes, regulations and must be
installed by a licensed electrician.
2. All electrical connections must be made
according to the Electrical Connection Diagram
located on the panels of the indoor and
outdoor units.
3. If there is a serious safety issue with the power
supply, stop work immediately. Explain your
reasoning to the client, and refuse to install the
unit until the safety issue is properly resolved.
4. Power voltage should be within 90-110% of
rated voltage. Insufficient power supply can
cause malfunction, electrical shock, or fire.
5. If connecting power to fixed wiring, a surge
protector and main power switch should be
installed.
6. If connecting power to fixed wiring, a switch
or circuit breaker that disconnects all poles
and has a contact separation of at least 1/8in
(3mm) must be incorporated in the fixed
wiring. The qualified technician must use an
approved circuit breaker or switch.
7. Only connect the unit to an individual branch
circuit outlet. Do not connect another appliance
to that outlet.
8. Make sure to properly ground the air
conditioner.
Split Type Air Conditioner / User Manual