CAMP Andry Manual page 20

This product is warranted against any faults in materials or manufacture for 3 years from the purchase
SPECIFIC INFORMATION
INSTRUCTIONS FOR USE
Summary
use to protect and prevent against the risk of falling from a height in rescue operations, in work at a height, in
a device for reducing the friction of a loaded rope so that heavy loads can be more easily lifted or lowered (see
Table A).
Use
Tables A and . The pulley must be attached
to a safe anchor. The rope must run in the groove of the sheave [6] ( ). For the Janus and the Dryad the main
attachment holes [1] of the two side plates [4] and the central plate [5] must be clipped together ( ). For the
Naiad, do not clip the main attachment hole [1] with a secondary attachment hole [2] or with the becket [3] ( ).
The Naiad and the Janus can be used for tyrolean traverses including safety line ( ). Some examples of pulley
block are indicated in Table B. Humidity and cold temperatures may change the dynamic performance of this
CHECKING AND MAINTENANCE
Check the wheel's rotation before use. If after cleaning, the wheel does not turn freely, lubricate the axis of
the wheel with a silicon lubricator. Note: Cleaning and lubrication is recommended after every use in a marine
environment. If, after oiling, the defect persists, the pulley must be taken out of use.
REVISION
recorded on the product's life sheet: keep this literature for inspection and reference for the life of the device.
Check the legibility of the product's markings. In case of one of the following defects are present, the product
should be withdrawn from service immediately:
• malfunction or slackening of the wheel on the axle
• presence of cracks in the metallic parts
• permanent deformation of a metallic part
• deep corrosion that seriously alters the surface state of the metal (which does not disappear after a light rubbing
with emery paper)
• wheel's use causes a detectable reduction of the groove in the pulley wheel
Any product or component showing any defect or wear, or if in doubt, should be withdrawn from service
immediately. Each product in the safety system can be damaged during a fall and must be always inspected before
external signs are visible.
LIFETIME
The lifetime of the product is unlimited, unless any defect appears and provided that periodic inspections are
18