Electrical Connection - Ametek Motec MC3000B Installation And Operating Instructions Manual

Please ensure that there is sufficient corrosion protection for the boreholes.
Utilisez pour la fixation 4 vis M6 x 15 ou quatre vis à tôle 6 x 15 et 4
EN
rondelles éventail M6. Veillez à une protection suffisante contre la corrosion,
ébavurez les passages de câbles et utilisez des passe-fils.
Deburr the cable breakthrough and use cable grommets.
Insert the camera into the bracket.
Caution:
The label is located on the bottom of the
camera.
Fasten the camera on the mounting bracket with 4 screws M6 x 10, tooth
washers M6 and insulating washers M6. Do not tighten the screws beyond
finger-tight. The camera will be adjusted later.
3.2

Electrical connection

Connect the MC3000B/-VA to a camera input of a Motec control unit or Motec
monitor with the appropriate connection cables. Follow the instructions in the
operating manual of the instrument. For screwed plug connections, tighten the
thread tight enough to ensure the plug will not leak, but not enough to overtighten
or even destroy the screwed plug connection. If you use a wrench or some other
tool, exercise due caution. Seal the cable connections properly with the accom-
16