Electrical Connection - Ametek Motec MC5201 Series Installation And Operating Instructions Manual

Align the camera in the retaining bracket
so that the outer edges of the retaining
bracket and the camera are parallel to
each other and the type plate faces the
cabin of the crane.
The shafts of
MP5000-2 and motorised zoom camera
MC5201 are secured in the designated
mounting tube on the crane jib and addi-
tionally secured with a safety chain (me-
chanical fall arrester) and a push-type split
pin.
CAUTION! Never walk onto the crane system without a mechanical fall
Connect the connector of the MC5201 motorized zoom camera using the MK279
cable. Depending on the type of installation, you may notice some silicon paste
leaking from the shaft of the MP5000-2 suspended mount. This does not affect
the function.
3.2

Electrical connection

Connect the camera input of a Motec control unit or Motec monitor with the ap-
propriate connection cables. Follow the instructions in the operating manual of
the instrument. For screwed plug connections, tighten the thread tight enough to
ensure the plug will not leak, but not enough to overtighten or even destroy the
screwed plug connection. If you use a wrench or some other tool, exercise due
caution. Seal the cable connections properly with self fusing electrical tape. To
do this, unwind the tape around the plug while pulling lightly. In addition to further
improving the seal, this will also provide additional protection for the screw con-
nection and prevent it from accidentally coming loose. Use new fusing tape if you
open the screw connection again later.
suspended mounting
arrester! Risk of an accident.
260
104
MP5000-2
GMC5100-14
Model: Model:
Art.-Nr.: Art.-Nr.:
S/N: S/N:
Oberweyerer Str.21 D-65589 Hadamar Tel. 064 33/91 45-0 Fax 91 45-45 Oberweyerer Str.21 D-65589 Hadamar Tel. 064 33/91 45-0 Fax 91 45-45
MC5201
Align this side to
Diese Seite
the crane
zum Kran ausrichten
80
86
EN
19