Product Safety; Additional Dangers - Ametek Motec MC3000B Installation And Operating Instructions Manual

2.1

Product safety

The product is designed to the state of the art and meets the requirements of
EN
generally recognised safety rules. The system must only be operated in flawless
condition and in accordance with the instructions in the operating manual.
2.2

Additional dangers

Before you begin using the camera system, check for visible defects and obser-
ve the system for potential faults during operation. If defects are discovered in a
camera system that have a detrimental effect on safety, it must not be put in ope-
ration or must no longer be used. Defects that are detrimental to safety must be
rectified before the system is placed in operation again. Dangers arising from the
use of special working materials and untested, unapproved accessories, confi-
guration, installation or operation of the device cannot be monitored. The user
is therefore responsible for ensuring correct use of the products. Compliance
with the applicable manufacturer's specifications and safety instructions for the
machine and/or vehicle is mandatory when installing components and operating
the system.
Do not lay cables close to the motor or other sources of heat.
Protect cables against damage with cable ducts or protective tubes.
Make certain cables are not twisted.
Cables must not be painted and must not come in contact with solvents.
If the cable is too long, it can be routed in loops.
Please take note of the mandatory installation radius for the camera cable:
15 x cable diameter for fixed installation, 22 x cable diameter for flexible
installation.
Do not tighten the cable connections too tightly.
Screw the plug connections hand-tight.
The power supply must only be taken from the contacts designatet by the
vehicle manufacturer for this purpose. Power take-off at signal outputs may
create disturbances or severe damage
14