Table of Contents
Advertisement
1.
Tap
.
2. Tap
to select Device Settings.
3. Tap
.
4. Tap
to select USB Class.
5. Tap
to set the USB audio class.
After you select a different audio class, wait for 10 seconds while the USB software
reloads.
Installing the Windows™ driver for USB Class 2
If the USB audio class of the USB1 socket is set to Class 2, a driver needs to be installed on
Windows™ computers before you can connect to the unit.
1.
Set the USB1 socket to Class 2.
For more information, see "Setting the USB audio class" on the previous page.
►
2. If there are any ASIO drivers on the computer, uninstall them.
3. Connect the computer to the USB1 socket of the unit.
4. Go to
www.dcsaudio.com/search/results?q=driver
5. Download the Windows™ USB Class 2 driver.
6. Unzip the file to a temporary directory.
7.
Run the file.
8. Follow the on-screen instructions.
9. After the driver is installed, restart the computer.
Enabling and disabling the buffer
By default, there is a buffer delay in the unit. This delay gives the unit time to mute before you
hear audible clicks caused by changes in sample rate or clock frequency. The delay is
0.72 seconds with 44.1 kS/s data, and 0.16 seconds with 192 kS/s data.
If the unit is connected to a television or video equipment, you may need to disable the buffer
to keep the sound in sync with the picture.
1.
Tap
.
2. Tap
to select Device Settings.
3. Tap
.
4. Tap
to select Buffer.
5. Tap
to enable or disable the buffer.
Buffer on
Buffer off
37
Advertisement
Table of Contents
