Pro-Form 1210 RT User Manual page 10

7. Attach the Base Cover (84) to the Base (94)
with four #8 x 1/2" Screws (1). Be careful not
to overtighten the Screws.
With the help of a second person, tip the tread-
mill so that the Base (94) is flat on the floor.
8. Set the console assembly face down on a soft
surface to avoid scratching the console.
Identify the Right Handrail (79). Hold the Right
Handrail near the console assembly. Route the
console wire through the large holes in the top
and bottom of the Right Handrail.
Set the Right Handrail (79) on the Console
Frame (81). Start a 1/4" x 1/2" Screw (8) with a
1/4" Star Washer (12) into the Right Handrail.
Then, start two 5/16" x 1 1/2" Screws (4) with
two 5/16" Star Washers (9) into the Right
Handrail. Make sure that the console wire is
not pinched. Do not tighten the three Screws
yet.
Attach the Left Handrail (not shown) as de-
scribed above. Note: There is not a wire on
the left side.
All manuals and user guides at all-guides.com
10
7
84
94
1
1
8
79
8
12
Console
Assembly
Console
Wire
4
9
81