Technical Information Error Messages; Technical Data - uebe cyclotest mySense Instructions For Use Manual

Table of Contents

Advertisement

Technical information
Error messages
The measured temperature is above 43.99°C and is
therefore outside the measuring range.
The measured temperature is below 32.00°C and is
therefore outside the measuring range.
The ambient temperature is above 40.00°C and is
therefore outside the permissible operating condi-
tions.
The ambient temperature is below 10.00°C and is
therefore outside the permissible operating condi-
tions.
Fever warning. Temperature higher than 37.5°C meas-
ured.
Device memory is full. Connect the
thermometer to the cyclotest
ense app to transfer the measured val-
ues to the app.
Battery low. Have a spare battery ready.
Battery flat. Please change the battery.
EN-16
myS-
®

Technical data

Type:
Measuring points/body
reference points:
Temperature unit:
Measuring range:
Technical information
No display after switching on. Check whether the bat-
tery is positioned correctly and the polarity (+/-) is cor-
rect. If the error persists, change the battery.
Bluetooth connection error
Sensor error. If this occurs repeatedly, please contact
the cyclotest
service hotline.
®
Measurement was cancelled prematurely. Repeat
the measurement and wait until the measurement is
compete before removing the thermometer from the
measurement point.
Calibration error. If this occurs repeatedly, please con-
tact the cyclotest
service hotline.
®
The device is in technical test mode. Switch it off and
on again after a few seconds to return to normal mode.
Maximum thermometer, direct mode
rectal, oral, vaginal
°C
32.00°C to 43.99°C
EN-17

Advertisement

Table of Contents
loading

Table of Contents