Table of Contents
Advertisement
Operating the device
• If more than 25 saved measurements have
not been transferred to the mySense App, the
message "APP/FULL" (Figures 5 and 6) appears
on the display to remind you to transfer the
measurement values to the app as soon as
possible.
• If you perform more than 30 measurements
without transferring the values to the myS-
ense app, the oldest value is deleted to make
room for a new measurement.
The device is now ready to perform a new meas-
urement (Figure 7). You will then hear another
beep.
Never begin a measurement before this mes-
sage appears on the display or before you hear
the second beep and the dash and °C icon flash
on the display. The thermometer must already
be in measurement mode when you start meas-
uring to be able to correctly record the progress
of the measurement.
Measuring wake-up temperature
Take the measurement within the selected measurement timeframe
immediately after waking up. Take the measurement even before you
get up. Measured values determined outside the measurement time-
frame will not be transferred to the mySense app.
You must have slept for at least five hours before taking a measure-
ment and must not have stood up in the last hour before the meas-
urement. If you have not had enough sleep, skip the measurement.
EN-10
• Place the probe tip underneath your tongue on either the left-hand
or right-hand side. The temperature sensor must make good con-
tact with the tissue.
• Close your mouth and breathe calmly through your nose so that
the measurement result is not affected by the air that you breathe.
Figure 5
• As long as the measured temperature re-
mains below the measuring range (32.00°C
to 43.99°C), the display shows L (low) (Figure
8). Have a little patience during the measure-
ment. The sensor must first warm up from
room temperature to body temperature.
Figure 6
• During the measurement, the current temperature is shown on the
display. You must wait until the measurement is complete to ensure
the accuracy of the temperature value.
• A long beep indicates that the measurement
is complete. The measurement value is shown
on the display (Figure 9).
Figure 7
• If the thermometer measures an elevated
temperature of 37.50°C or above, you will
hear 10 beeps in rapid succession. The display
switches between showing the temperature
and "HI" (fever alert, Figure 10).
• The device now tries to establish a Bluetooth
connection to transfer the measured value to
the mySense app. Make sure that the smart-
phone is within range, Bluetooth is enabled
and the mySense app is running.
Operating the device
Figure 8
Figure 9
Figure 10
EN-11
Advertisement
Table of Contents
