Table of Contents
Advertisement
Operating the device
• If the connection is successful, the "APP" indi-
cator appears and the display lights up green
(Figure 11). Once the data has been trans-
ferred, the thermometer switches off auto-
matically (Figure 12).
• If the device cannot establish a connection,
the measurement value is stored on the de-
vice to be transferred later. The device can
temporarily store up to 30 measurement val-
ues. The thermometer then switches itself off
(Figure 12).
Manually transferring data to the mySense app
If the measurements cannot be transferred to the mySense app im-
mediately after the measurement (e.g. if your smartphone is not with-
in Bluetooth range or the mySense app is not open), you can transfer
the measurements to the mySense app at a later date. To do so, pro-
ceed as follows:
• Open the mySense app on your smartphone.
• With the device switched off, press and hold
the data transfer button
ond, but no more than 5 seconds, until the
Bluetooth symbol
appears in the display. If
you hold down the button for more than 5
seconds, you will enter memory recall mode.
• The device now connects to the app via Blue-
tooth (Figure 1).
• If the connection is successful, the "APP" indi-
cator appears and the display lights up green
(Figure 2).
EN-12
Figure 11
Figure 12
for at least 1 sec-
If the device cannot connect to the mySense app, it switches itself off
after 60 seconds. If this occurs, check whether Bluetooth is enabled on
your smartphone and that the mySense app is running, then try again.
Recalling saved measurement values
The thermometer has a measurement value memory with 30 save
slots. The measurement values are saved automatically together with
the date and time of the measurement. The most recently measured
value is stored in save slot 1; the value measured prior to that is stored
in save slot 2, and so on. If more than 30 measurements are taken,
the oldest value (no. 30) is deleted so that the most recent value (no.
1) can be saved.
The measurement values and lots of additional information are saved
in the mySense app, where they can be analysed with ease.
You can also recall the last 30 readings directly from the mySense ba-
sal body temperature thermometer. To do so, proceed as follows:
• With the device switched off, press and hold the
memory recall button
until the
vice switches to memory mode (Figure 1).
• The most recently meas-
ured value, no. 1, is now
displayed (Figure 2, Figure
3). The display switches
Figure 1
between the measure-
ment value and the year,
month/day and time. For
measurement values that
have been transferred to the mySense app, the symbol
played.
Figure 2
Operating the device
for at least 5 seconds
icon appears on the display. The de-
Figure 2
Figure 1
Figure 3
is dis-
EN-13
Advertisement
Table of Contents
