Battery Display/Changing The Battery; Changing Devices - uebe cyclotest mySense Instructions For Use Manual

Operating the device
• By repeatedly pressing the memory recall
key , you can call up the previous measure-
ments (no. 2, no. 3 ...).
• If no measurement values are saved, the fol-
lowing appears on the display (Figure 4):

Battery display/changing the battery

The device is equipped with a CR2032 lithium battery.
If the battery icon flashes on the display while
the thermometer is in use, the battery is low
(Figure 1). You can still perform some tempera-
ture measurements at this point, but you should
have a spare battery ready.
Change the battery if:
– After switching on the device, the "battery
flat" indicator (Figure 2) appears on the dis-
play. You must insert a new battery before
you can take any temperature measure-
ments.
– Nothing is shown on the display despite pressing the on/off but-
ton.
• Unlock the battery cover by turn-
ing it past the marker to the left.
Then lift the cover off.
• Remove the old battery and insert
a new battery (CR2032) with the
"+" symbol facing up.
EN-14
Figure 4
Figure 1
Figure 2
Battery com- Battery com-
partment cover partment cover
unlocked locked
• Place the cover back on the battery compartment and lock it in
place.
After changing the battery, the thermometer must be connected to
the mySense app so that the date and time can be resynchronised. To
do this, open the mySense app and turn on the thermometer. Until
you have done this, you cannot take any new temperature measure-
ments.
Measurement values stored on the device are retained when the bat-
tery is changed.

Changing devices

Each mySense basal body temperature thermometer has a unique
signature assigned to a specific user. Signatures are assigned during
initial setup when the device is synchronised with the mySense app
for the first time.
If your device is lost or faulty, you can assign a new mySense basal
body temperature thermometer to your user account.
To do this, go to "Menu → Settings → Replace thermometer" in the
mySense app and follow the instructions.
Please note: If you change device during a cycle, the current cycle be-
comes inactive in the mySense app. For your safety, the mySense app
only accepts measurement data from a single device during a cycle.
Operating the device
EN-15