Table of Contents
Advertisement
ON - USB device connected to the USB port
USB 2
OFF - No USB device installed
Fast Blinking - Data being transferred to or from the USB device
2.1.3 Rear Panel
This is a spring-loaded "Soft Switch".
If power is Off, press once to turn On.
Power Switch
If power is On, press once to start the Shutdown sequence.
During Shutdown, the Ready LED will blink. When Shutdown is
completed, all LEDs will turn off.
Power Input
Connect the supplied power adapter here.
This button has 2 functions:
If the NAS's IP Address is lost, press and hold this button for 2
Reset
seconds. The IP Address will be set to the default (DHCP client)
Button (IP/
and it will beep once to indicate the reset has occurred
Password)
If the NAS administrator's password is lost, press and hold this
button for 10 seconds. The password will then be cleared (no
password), and the NAS will beep twice.
For USB port 1 device eject. Press and release to prepare the
USB Eject
USB device for removal. When the USB LED turns off, it is safe
Button 1
to remove the USB device.
Connect your USB Hard Disk Drive or USB Flash Drive here.
USB Port 1 &
The USB HDD support FAT and NTFS (Read only) file format
2 (Up/Down)
Connect USB printer
For USB port 2 device eject. Press and release to prepare the
USB Eject
USB device for removal. When the USB LED turns off, it is safe
Button 2
to remove the USB device.
LAN
Use this to connect the NAS to your 10/100/1000Base-TX
connector
switch or device.
Advertisement
Table of Contents
