Performance Verification With - LeCroy LSA1000 Operator's Manual

Performance Verification with

Remote LSA is the simplest way to run the LSA1000's basic
— without the need for remote control
operations
commands. Thus we recommend that Remote LSA be used
for the initial performance verification of the LSA1000.
1. Ensure that your PC has the Ethernet connection
established with the LSA1000 (see Chapter 4).
2. Connect the LSA1000's "REF OUT" to "CH 1".
3. Start Remote LSA.
4. In the "Timbase + Trigger" panel click on
the trigger to automatic.
5. Select channel
6. The program should display a 10MHz square waveform
of approximately 400mV amplitude, as shown on the
next page.
This process using Remote LSA is a simple means of verifiing
that the LSA1000 is working properly when first received.
Remote LSA is also recommended as a visual diagnostic tool
during LSA1000 program development.
5–11
Remote LSA
from the "Channel" panel.
to set