andrews MAXXflo EVO CWH 150/302 Installation And Maintenance Manual page 62

6.2.2 FLUE TEMPERATURE SENSOR (B8)
This is located at the Flue outlet of the heat exchanger.
• Unplug the sensor from the loom (squeeze the catch to release).
Connector
• Remove sensor by unscrewing anti-clockwise
• Replacement is the reverse.
6.2.3 COMMON FLOW TEMPERATURE SENSOR (B10)
This is located on the top left hand side of the case, to the left of the top control PCB
• Unplug the sensor from the loom (Squeeze the catch to release).
Common fl ow sensor
6.2.4 GUI DISPLAY
This is located in the centre of the heater inside the front cover.
• Switch off electrical supply to heater
• Remove the 4 fi xing screws located at the rear of the screen.
Securing screws
• Push off the wiring connector from the rear of the GUI
• Replacement is the reverse.
Maintenance
heater
g connector from the rear of
Flue sensor
62
Connector
MAXXfl o EVO 150/302