Audient ASP510 User Manual

Audient ASP510 User Manual

5.1 surround sound monitor controller
Hide thumbs Also See for ASP510:

Advertisement

Quick Links

5.1 SURROUND SOUND
MONITOR CONTROLLER
User Manual V1.0
audient.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ASP510 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Audient ASP510

  • Page 1 5.1 SURROUND SOUND MONITOR CONTROLLER User Manual V1.0 audient.com...
  • Page 2: Safety Warnings

    AC power source. To prevent electrical shock and fire hazard follow all the Switched to the 230v position the unit Thank you for selecting the ASP510 surround sound monitor controller. warnings and instructions marked on the will operate without performance ASP510 Surround Processor rack unit.
  • Page 3: Unpacking And Installation

    Unpacking & Installation Audio Connections Your ASP510 Controller has been The ASP510 Controller has been To unbalance the outputs of the ASP510 Mechanical Installation carefully and meticulously tested and designed and developed to provide the -ve Pin should be connected to its inspected before dispatch.
  • Page 4: Studio Connections

    Studio Connections Control Interfaces The ASP510 allows various logic control When you first turn on your ASP510 it will signals from the host mixing console load the following default set-up: to be interfaced to allow continued operation of console solos etc. These •...
  • Page 5: Room Setup

    110 ° can be found on our website as a guide control has been carefully developed to Sweet to the ways that the ASP510 can be give optimum resolution between the Spot integrated into a range of Surround 12.00 o’clock and 5.00 o’clock positions.
  • Page 6: Functions And Controls

    Monitor Level Trim Controls Audio and Logic Connections system. It is connected to and controlled monitors via the ASP510. by the ASP510 remote unit via an RS485 The Trims provide adjustment of +/- Allowing connection with other devices link. The six speaker outputs are each 10dB for each speaker output.
  • Page 7 To make system setup straight forward Ref Button If the logic sense ports have been the ASP510 has a built in Pink Noise connected to the host mixing console generator. The Reference button sets all monitor the ASP510 will automatically detect and...
  • Page 8 Functions and Controls Functions and Controls To lock a second or third source simply repeat this action. To cancel, hold down the button until it extinguishes. To GANG together two or more of the Stereo (or Surround) sources, hold down the first member of the Gang until it flashes then release it and hold down the second member until it too flashes...
  • Page 9: Specifications

    Noise accident. At speaker outputs: ......<-92dBu 22Hz - 22kHz We accept a liability to repair or replace your ASP510 as described above. We do not accept any additional liability. Crosstalk This warranty does not affect any legal rights you may have against the (Source/source): ......>80dB 1kHz...
  • Page 10: Block Diagram

    Block Diagram...

Table of Contents