Indicator Problem - 3onedata IMC100-2T1F-1D User Manual

-
-
-
How about the order of port self-adaption state detection?
2.
The port self-adaption state detection is conducted according to following order:
1000Mbps full duplex, 100Mbps full duplex, 100Mbps half-duplex, 10Mbps full
duplex, 10Mbps half-duplex, detect in order from high to low, connect
automatically in supported highest speed.

5.3 Indicator Problem

1. Power indicator isn't bright, what's the reason?
Possible reasons include:
-
-
-
Link/Act indicator isn't bright, what's the reason?
2.
Possible reasons include:
-
-
-
-
Connected network cable and switch port keep invariant, change other
computers;
Connected network cable and computer keep invariant, change other
switch port;
If the switch port faults are confirmed, please contact supplier for
maintenance.
Not connected to the power socket; troubleshooting, connected to the
power socket.
Power supply or indicators faults; troubleshooting, change the power
supply or device test.
Power supply voltage can't meet the device requirements; troubleshooting,
configure the power supply voltage according to the device manual.
The network cable portion of Ethernet copper port is disconnected or bad
contact; troubleshooting, connect the network cable again.
Ethernet terminal device or network card works abnormally; troubleshooting,
eliminate the terminal device fault.
Not connected to the power socket; troubleshooting, connected to the
power socket.
Interface rate doesn't match the pattern; troubleshooting, examine whether
the device transmission speed matches the duplex mode.
3onedata proprietary and confidential
Copyright © 3onedata Co., Ltd.
User Manual
23