3onedata IMC100-2T1F-1D User Manual page 18

Interface Element
Stop Bits (bits)
Interval (ms)
COM Mode
Work Mode
Settings
Sessions
Work Type
Local Port
Target Address
Target Port
LinkMode
DisconTimeOut
3onedata proprietary and confidential
Copyright © 3onedata Co., Ltd.
Description
Select stop bits of corresponding serial number. Options
include:
1bits;

2 bits.

Interval time of serial data to Ethernet data, value range is
1-500ms.
It's decided by software and hardware, there are RS232,
RS485, RS422 three modes.
Work Mode Settings Column
1-4, each serial port of serial server supports 1-4 sessions.
Session refers to the process serial server transmits data
received from serial port to Ethernet via socket connection.
Choose the work type of serial port. Options are:
TCP Server

TCPClient

UDP

TcpAuto

1-65535, it refers to TCP port that is provided by serial server
and can be connected by other TCP/IP nodes. The port is
connected to relative serial ports of serial server. System will
automatically distribute local port number when it's "0", fixed
local port number will be used when it's not "0".
IP address or domain name address to be connected to serial
server, both can be corresponding to the host address in
Internet.
1-65535, TCP port number to be connected to serial port.
Choose the link mode of serial port. Options are:
Link: it means this device would connect when it is

powered on. It would reconnect immediately even it is
disconnected;
Data Trigger: it means the corresponding port of this

device would connect once it receives data.
If no activity happens within the specified time, the system
would send connection detection message to check whether
the connection is valid. If it has sent successive probe packet
User Manual
12