Table of Contents
Advertisement
switch is reachable.
Before local configuration, please make sure the computer IP address is on the
same subnet as the one of switch.
Notes:
While first configuring the switch, if it is a local configuration mode, please make sure
that the network segment of current PC is 1.
E.g.: Assume that the IP address of the current PC is 192.168.5.60, change the
network segment "5" of the IP address to "1".
Operation Steps
Amendment steps as follows:
Step 1
Open "Control Panel > Network Connection> Local Area Connection> Properties>
Internet Protocol Version 4 (TCP / IPv4)> Properties".
Step 2
Change the selected "5" in red frame of the picture below to "1".
Click "OK", IP address modifies successfully.
Step 3
Step 4
End.
In windows system, if user adopts the advanced configuration function of IP address and
accesses the switch device via setting IP dummy address, the following managed functions
can't be achieved: IEEE 802.1x polling.
3onedata proprietary and confidential
Copyright © 3onedata Co., Ltd.
User Manual
2
Advertisement
Table of Contents
