Changing The Flash Intensity Setting; Using Flash Assist - Casio Exilim EX-Z57 User Manual

BASIC IMAGE RECORDING

Changing the Flash Intensity Setting

Perform the following steps to change the flash intensity
setting.
1.
In a REC mode, press [MENU].
2.
Use [ ] and [ ] to select the "REC" tab.
3.
Use [ ] and [ ] to select "Flash Intensity",
and then press [ ].
4.
Use [ ] and [ ] to select the setting you
want, and then press [SET].
To make flash intensity:
Stronger
Normal
Weaker
IMPORTANT!
• Flash intensity may not change if the subject is too
far or too close to the camera.
Select this setting:
+2
+1
0
–1
–2

Using Flash Assist

Recording a subject that is outside the flash range can
cause the subject to appear dark in the resulting image,
because not enough of the flash reaches the subject. When
this happens, you can use flash assist to correct the
brightness of the recorded subject, so it appears as if the
flash illumination was sufficient.
disp
Flash assist used
1.
In a REC mode, press [MENU].
2.
Use [ ] and [ ] to select the "REC" tab.
3.
Use [ ] and [ ] to select "Flash Assist", and
then press [ ].
62
disp
Flash assist not used