Advertisement
Available languages
Available languages
IHW 35, IHW 55
2. Technical data
Description
Mounting type
Mounting location
Design
Water connection spigot
Permissible operating pressure
Minimum flow pressure
Switch-on volume
Temperature increase 30 K
Load profile
1)
Energy efficiency class
Annual energy consumption
Nominal power
Rated voltage
Mains frequency
Rated current
Specific resistance at 15°C
Electrical connection
Protection class
Protection class
Dimensions W x H x D
Weight
3. Use
The instantaneous water heater is only suitable for
one tap. The unit should be mounted as close to this
as possible.
The unit may only be used for heating drinking water.
in households and similar purposes within closed and
frost-free rooms.
4. Device assembly
The unit can be used as an under-sink unit or as an
over-sink unit (turned by 180°).
NOTE
The unit may only be installed and put into operation
by a specialist.
Remove the upper part of the housing by loosen-
ing the upper screw and swinging the housing out
towards the front.
Mark the drill holes,
www.dimplex.eu
Unit
-
-
-
Inches
MPa
MPa
l/min
i/min
-
-
1)
kWh
kW
V
Hz
A
Ohm/cm
1/N/PE
I
IP
mm
kg
IHW 35
Under table or over table
Vertical on the wall
Small instantaneous water heater
3/8
0.6
0.12
1.2
1.7
XXS
A
471
3.5
230 ~
50
15.2
1100
Mains cable with plug
With protective conductor
25 (jet-proof)
170 x 225 x 75
1.2
drill the attachment hEnglisholes and insert dow-
els,
screw in the screws.
2105/A
English
IHW 55
2.0
2.6
XS
466
5.5
23.9
Fixed connection
EN-3
Advertisement
