Panasonic KX-HTS Series Manual page 41

3.2.7 Wall Mounting
Mounting on a Concrete or Mortar Wall
The included screws may be used when mounting the main unit on a concrete or mortar wall. User
supplied anchor plugs are also necessary.
1. Place the template (found on the last page of this manual) on the wall to mark the 2 screw
positions.
Note
When you print out the template, the distance on the paper output may deviate slightly from the
indicated measurement. In this case, use the indicated measurement.
2. Drill holes in the wall as marked and fit the anchor plugs (not included) into the holes.
3. Fit the washers on the screws, and drive the screws into the anchor plugs.
Note
• As indicated above, do not tighten the screw fully.
• The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
• Do not block the operations of the cabinet. Allow space of at least 20 cm above and 10 cm at the
sides of the cabinet.
• Make sure that screw heads are the same distance from the wall.
• Install the screw perpendicular to the wall.
• Be careful not to drop the cabinet.
225
(8.86in)