Care And Maintenance - MrCool DIY E Star Series Installation & Owner's Manual

Care and Maintenance

CAUTION
The power supply must be disconnected before
attempting any kind of cleaning or service.
Before performing maintenance, turn the power
off to the unit and then disconnect the power to
the circuit at the breaker. Failure to do this could
cause electrical shock and injury.
DO NOT use benzene, thinner, polishing
powder, or similar solvents for cleaning.
These could cause the plastic to deform
and/or crack.
DO NOT clean the unit with excessive
amounts of water.
DO NOT touch the metal parts of the unit
when removing the filter. Injuries can occur
when handling the sharp metal edges.
DO NOT use water to clean the inside of the
unit. Exposure to water can destroy the
insulation, which could lead to electric shock.
1
2
Tab
Operating Instructions
Wipe the unit with a soft dry cloth. If the unit is very dirty, wipe it with
a cloth soaked in warm water.
DO NOT use bleach or abrasives.
NOTE: A clogged air filter can greatly reduce heating and
cooling efficiency of this unit. It is recommended to clean the
unit every 2 weeks.
1. Open the front by carefully lifting both ends at the same time. As
you continue lifting, at a certain angle there will be an audible click
and the lid will become self-supporting. Some models are
equipped with suspension bars that are required to prop the lid
open.
2. Use the filter tabs to lift filter slightly upward and then pull it
toward you.
mrcool.com
mrcool.com
DO NOT use a chemically treated cloth or
duster to clean the unit.
DO NOT touch the air freshening (Plasma)
filter for at least 10 minutes after turning off
the unit.
DO NOT clean the unit with combustible
cleaning agents. These could cause fire and/or
deformation of the unit.
DO NOT wash the air filter with water hotter
than 104°F (40°C).
DO NOT expose the filter to direct sunlight, as
this could cause it to shrink. Allow the filter
to dry in the shade.
3
Page 14