Advertisement
Enroll the Peripheral with QR and serial No.
2
1. In the APP, tap the icon "+"and scan the QR code or serial No. on the peripheral.
2. Loosen the screw and remove rear panel.
3. Power on the peripheral, and it will be automatically enrolled to the control panel.
xxxx
Device
3
Installation
1. Check Signal Strength
Enter the signal checking mode by operating on the control panel. Trigger the device.
Solid Green for 3 s - Strong Signal
Solid Orange for 3 s - Medium Signal
Solid Red for 3 s - Weak Signal
Red light flashes for 3S - Lost Signal
2. Install the tag reader.
Note: The additional force shall be equal to three times the weight of the equipment but not less than 50N. The equipment
and its associated mounting means shall remain secure during the installation. After the installation, the equipment, including any associated mounting
plate, shall not be damaged.
a. Secure the rear panel on the wall with four screws.
Signal Strength Test
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
2
7 times
Advertisement
