Delete Encapsulation; Add A Vcc - Paradyne Hotwire 6212 User Manual

5.9.2 Delete Encapsulation

To delete encapsulation, select a VCC entry and then click on the Delete Encap button.

5.9.3 Add a VCC

To add a VCC entry, complete the following steps.
STEP 1: Click on the Add VCC button. The VCC screen appears.
STEP 2: Enter values for the parameters (explained below).
STEP 3: Click on the Apply button at the bottom of the page.
VPI
VCI
Peak Cell rate
(cells/sec)
Average Cell rate
(cells/sec)
Burst size (cells)
CDVT (cells)
Type
62
Virtual Path Identifier (VPI) that identifies this ATM
connection. The valid range is 0 to 4095.
Virtual Channel Identifier (VCI) that identifies this ATM
connection. The valid range is 0 to 65,535.
Defines the fastest rate a user can send cells to the
network. It is expressed in cells per second.
Defines the maximum sustainable average rate a user can
send cells to the network. It is expressed in cells per
second. This specifies the bandwidth utilization. This value
must always be less than or equal to the Peak Cell Rate.
Maximum number of cells the user can send at the peak
rate in a burst, within a sustainable rate.
Constrains the number of cells the user can send to the
network at the maximum line rate.
Select data or voice
July 2004 6212-A2-GB20-20