White Balance R/G/B; Projecting Srgb-Compatible Pictures; Adjusting The Position - Panasonic PT-L780NTU Operating Instructions Manual
Panasonic operating instructions lcd projector pt-l780ntu pt-l780u
Hide thumbs
Also See for PT-L780NTU:
- Operating instructions manual (146 pages) ,
- Brochure & specs (4 pages) ,
- Operating instructions manual (42 pages)
Table of Contents
Advertisement
WHITE BALANCE R/G/B
(RGB only)
This is used to adjust the white
areas of the picture if they appear
colorised. Press the I button to
make the selected color lighter.
Press the H button to make the
selected color stronger.
Projecting sRGB-
compatible pictures
sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictures to be
reproduced more faithfully, make
the following settings.
# Press the F F or G G button to
select "PICTURE MODE", and
then use the I I or H H button to
select "NATURAL".
$ Press the F F or G G button to
select "COLOR TEMP.", and
then use the I I or H H button to
select "STANDARD".
% Select the STANDARD from the
menu screen by pressing the
F F or G G buttons and then press
the ENTER button.
& Select the LAMP POWER item
in the OPTION menu by
pressing the F F or G G buttons
and set to "HIGH" by pressing
the I I or H H buttons. (pages 44
and 45)
NOTE:
B sRGB is only enabled when RGB
signals are being input .
38
Adjusting the position
When the input signal is RGB, first
press the AUTO SETUP button to
initiate automatic positioning.
If the optimum setting is not
obtained when AUTO SETUP is
carried out, adjust by the following
procedure.
Select the item pressing the F or G
buttons on the remote control unit or
the projector.
Press the I or H buttons, to adjust
the alternative items. For the
numerically adjustable items, press
the ENTER button to display an
individual screen, and press the I
or H buttons to adjust the setting.
Some items can be adjusted
pressing the F or G buttons.
When an RGB/DVI signal is being
input
"POSITION", "DOT CLOCK" and
"CLOCK PHASE" are not displayed
when a DVI signal is being input.
When an S-VIDEO/VIDEO signal is
being input
When a YP
P
signal is being input.
B
R
When the NETWORK/SD CARD is
selected (PT-L780NTU only)
39
Advertisement
Table of Contents
