Inserting The Batteries; Operating Range; Setting The Projector Ids Number For Remote Control Unit - Panasonic PT-L780NTU Operating Instructions Manual

Inserting the batteries

# Open the cover.
$ Insert the batteries so that the
polarities are correct, and then close the
cover.
AAA batteries
(two)
NOTE:
B Do not drop the remote control unit.
B Do not drop the remote control unit.
B Keep the remote control unit away from liquids. B Keep the remote control unit away from liquids.
B Remove the batteries if not using the remote control unit for long periods. B Remove the batteries if not using the remote control unit for long periods.
B Do not use rechargeable batteries. B Do not use rechargeable batteries.

Operating range

If the remote control unit is held so
that it is facing directly in front of the
remote control signal receptors on
the front or rear of the projector, the
operating range is within
approximately 7 m (23´) from the
surfaces of the receptors.
Furthermore, the remote control unit
can be operated from an angle of
±30° to the left or right and ±15°
above or below the receptors.
20
NOTE:
B If there are any obstacles in between B If there are any obstacles in between
the remote control unit and the the remote control unit and the
receivers, the remote control unit may
receivers, the remote control unit may
not operate correctly. not operate correctly.
B If strong light is allowed to shine onto B If strong light is allowed to shine onto
the remote control signal receiver, the remote control signal receiver,
correct remote control operation may correct remote control operation may
not be possible. Place the projector as not be possible. Place the projector as
far away from light sources as possible. far away from light sources as possible.
B If facing the remote control unit B If facing the remote control unit
toward the screen to operate the toward the screen to operate the
projector, the operating range of the
projector, the operating range of the
remote control unit will be limited by remote control unit will be limited by
the amount of light reflection loss
the amount of light reflection loss
caused by the characteristics of the caused by the characteristics of the
screen used.
screen used.
Setting the projector IDs number for
remote control unit
When controlling multiple projectors individually or simultaneously with a
single remote control unit, projector IDs must be set into the remote control
unit as described in the following steps.
#Press the ID SET button on the remote control unit.
ID number "ALL" will be displayed on the screen.
$Press and hold the ID SET button for more than 2 seconds.
The ID number will change into "1". The ID SET button will now toggle
through ID numbers "2", "3", "ALL" and "1" each time it is subsequently
pressed.
%Select the ID number you wish and then press the ENTER button.
When the projector ID coincides with the remote control unit
<If the MAIN POWER is ON>
The ID number will be displayed in white on the screen.
If the projector ID and ID for the remote control unit are not the same, the
projector ID is displayed in green.
<If the projector is in standby mode>
The Power indicator on the projector will flash for 5 seconds.
If the projector ID and ID for the remote control unit are not the same, the
Power indicator will stay illuminated red.
NOTE:
B The projector ID number in the remote control unit is set to "ALL" by
default. It is therefore not necessary to set a projector ID number when
only one projector is used.
B The projector can be turned ON/OFF from the remote control unit only if
the projector ID is set in the remote control unit. For more details on
projector ID setting, see page 46.
21