In an Emergency
WARNING!
•
Never position yourself under a
7
jacked vehicle.
•
Jack wrong positioning can
cause vehicle accidental fall, with
consequent severe risk for operator's
safety and damages to vehicle body.
•
Never use the jack to carry out
maintenance or repairs under the
vehicle.
300
• Insert the extension levers in the jack.
• Turn clockwise the extension lever
of the jack until the wheel is raised a
few centimeters off the ground.
• Completely unscrew the five bolts
and remove the wheel.
• Make sure that the contact surfaces
between spare wheel and hub are
clean and free of impurities.
• Fit the compact spare wheel with the
valve stem side out and secure it with
the five bolts previously removed,
without tightening them.
• Remove from the compressor case
the inflation hose and the cable with
a plug for the power outlet.
• Unscrew the valve cap of the compact
spare wheel and screw the fitting of
the inflation hose onto the valve.
• Insert the plug inside one of the
available power outlets fitted in the
boot or passenger compartment.
• Set the ignition device on ACC or
RUN position.
• Turn the compressor on by pressing
the switch.
• Stop the compressor pressing
switch again, when the pressure
indicated by the gauge reaches
the recommended level of 350 kPa
- 3,5 bar - 51 psi (
: chapter
"Tire Inflation Pressure" in section
"Technical Specifications") and screw
the cap on the compact spare wheel
valve.
CAUTION!
•
In order to obtain a more accurate
reading, the compressor should be
switched off when checking the tire
pressure of the compact spare wheel
on the pressure gauge.