Mazda MX-30 2020 Owner's Manual page 39

Essential Safety Equipment
Seats
5. A sound is activated when the
adjustment to the programmed
driving position is completed.
Using the transmitter
1. Unlock the driver's door using one
of the following methods.
Touch the sensing area of the
door release touch sensor.
Press the unlock switch on the
transmitter.
2. When you open the driver's door
within 90 seconds after unlocking
the doors, the adjustment of the
following parts starts.
Driver's seat
Active driving display (When the
power switch is switched ON, the
adjusted active driving display is
activated.)
Outside mirrors
A sound is activated when the
adjustment is completed.
Erasing programmed driving positions
Erasing the driving positions
programmed to the key
1. Switch the power switch OFF.
2. Press the SET switch continuously
until a sound is activated.
3. Press the lock switch on the
transmitter within 5 seconds after
the sound is activated.
NOTE
If you do not perform the operation
correctly, a sound indicating that the
programming has failed is activated.
2-12
▼ Adjusting the Front Passenger's
Seat
1. Seat Recline
To change the seatback angle, lean
forward slightly while raising the
lever. Then lean back to the desired
position and release the lever.
Make sure the lever returns to its
original position and the seatback is
locked in place by attempting to
push it forward and backward.
2. Height Adjustment
To adjust the seat height, move the
lever up or down.
3. Seat Slide
To move a seat forward or
backward, raise the lever and slide
the seat to the desired position and
release the lever.
Make sure the lever returns to its
original position and the seat is
locked in place by attempting to
push it forward and backward.